Special Regen
Special Regeneration Process: Standard Softener
Step 1: Turn off the water supply.
Step 2: Disconnect outlet hose from the outlet side of the softener.
Step 3: You can drain water by tilting unit over or turning it upside down with the head/cap ON. Once draining has been completed, flip the unit back upright and tap the black base against the ground a few times to get the resin to fall back down into the bottom of the tank.
Step 4: Remove top cap.
Step 5: Add 2 26oz boxes of table salt (mix salt with warm water and pour the solution into the softener if the water has been drained out)
Step 6: Put the top cap back on and slow rinse the unit for 25-30 minutes
Step 7: Fast rinse for 5 minutes
Step 8: Check the hardness at the output of the softener
Step 9: The test strips should read around 0-3 GPG, and your unit is ready for use!
Special Regeneration Process: Double Standard Softener
Step 1: Turn off the water supply.
Step 2: Disconnect outlet hose from the outlet side of the softener.
Step 3: You can drain water by tilting unit over or turning it upside down with the head/cap ON. Once draining has been completed, flip the unit back upright and tap the black base against the ground a few times to get the resin to fall back down into the bottom of the tank.
Step 4: Remove top cap.
Step 5: Add 4 26oz boxes of table salt (mix salt with warm water and pour the solution into the softener if the water has been drained out)
Step 6: Put the top cap back on and slow rinse the unit for 55-60 minutes
Step 7: Fast rinse for 5 minutes
Step 8: Check the hardness at the output of the softener
Step 9: The test strips should read around 0-3 GPG, and your unit is ready for use!